Install a Tactical Ring Base on Your Rifle

Quick answer

To install a tactical ring base on your rifle, you need to clean the receiver, align the base with the recoil lug, torque the screws to spec, and then mount the rings. The key is avoiding over-torque and ensuring the base is centered.

Installation steps

1. Clean the receiver: Use a degreaser and lint-free cloth to remove oil, dirt, and debris from the receiver's flat surfaces where the base will sit. Skipping this step can cause the base to shift.
2. Position the base: Place the base on the receiver, aligning it with the recoil lug or alignment pins. Ensure it sits flush without rocking. Check for any burrs on the receiver that prevent a flush fit.
3. Apply thread locker: Apply a drop of medium-strength thread locker (e.g., Loctite 242) to each screw before insertion. Too much thread locker can seep into the action; use sparingly.
4. Torque screws to spec: Using a torque wrench, tighten each screw in a crisscross pattern to the manufacturer's recommended torque value (typically 15–25 in-lbs). Over-torque can strip threads or crack the base.
5. Mount the rings: Attach the ring bottoms to the base, then place the scope and add the ring tops. Torque the ring screws evenly. Ensure the scope is level before final tightening.

Product facts

• Paire de colliers tactiques: These tactical rings are designed for robust, reliable use but do not include a universal interface. If your scope mount requires a universal interface, you'll need to order that separately for full compatibility.